In order to verify your dynamic rules you proceed as follows:


First you select a rule in the top section Rule Table. Next hover over the Check button in the header line of the Rule VM section and a drop-down selection pane appears.



Select Check single. A system message informs you when the rule application is carried out. Now you may check the results. The new or changed values have been added to the respective columns as defined in the Rule Manager. Once you are done proceed on testing the next rule.


 Note: only one single rule can be tested at a time.


Leaving the Rule Verify module deletes your test results.

updated on: 5/9/2019 ⏐updated by: Wolfgang Stoettner ⏐ v1.0.1